ACRONIS Disk Director 11 Home Betriebsanweisung PDF herunterladen (Seite 78)

 Help – lets you get help concerning the editor window, the program’s manufacturer and version.

Using controls

While all the operations can be accessed from the menu, the most frequently used operations are

available on the toolbar.

You can access almost all of the program's main functions (or menu items) with the help of F1, F2,…

F10 keyboard shortcuts and combinations like Ctrl+O, Ctrl+F, Alt+P, etc. For example, the dialog

window for searching volumes and/or hard disks for lines is performed by pressing the Ctrl+F key

combination. You can go to a sector according its absolute offset by pressing Alt+P. You can switch

between various main window view modes. For example, press F2 for the As Hex view mode, F6 for

the As Partition Table view mode, F7 for the As Boot Sector view mode. There are other available

shortcut keys.

The list of encodings is used to interpret the hard disk sector content. Selecting the necessary

encoding, will allow you to view the sector's content correctly interpreted in the right part of

program’s main window in the Hex mode.

8.2.3 Editing disks

The Edit menu lets you access the main operations with blocks of given hard disk sectors. You can

edit hard disk data directly in the fields of any view mode — see View (p. 75).

Let us consider the disk editing in the As Hex view mode.

Selecting data

Any view mode lets you select blocks of disk sectors with the mouse or with the keyboard.

In the Hex view mode, use the following to select blocks:

 With a mouse. Place the mouse pointer at the necessary sector byte and drag it to create a block

selection around the outside of all the bytes that you want to select.

 With a keyboard. Place the cursor at the necessary sector byte. Press and hold the Shift key and

use the arrow keys (or Page Up and Page Down keys) to create a selection.

Hint: Pressing the End key while holding the Shift selects the entire disk sector. To select all the disk sectors,

press Ctrl+A.

Editing disk data

Point the cursor to the block that you need to edit in the hexadecimal or character area in the main

window. Then, enter the required value. In other view modes, you should edit values in the

appropriate fields.

Use the Undo menu item to discard the last one or more changes. Undo all discards all the changes

you made.

Saving your changes

The changes you made will not be applied to the given disk sector immediately. Be sure to click Save

sector for changes to take effect.

Attention: After saving changes you will not be able to undo them.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 95 96

Keine Kommentare

ACRONIS Disk Director 11 Home Betriebsanweisung Seite 78