ACRONIS Backup & Recovery 11 Betriebsanweisung PDF herunterladen (Seite 128)

Also, you have to map the volumes manually if they are Linux logical volumes, or Linux software RAID

(MD devices). For more information on recovering logical volumes and MD devices, see Recovering

MD devices and logical volumes (p. 38).

The automatic mapping is performed as follows.

1. If the disk or volume is recovered to its original location, the mapping process reproduces the

original disk/volume layout.

The original location for a disk or volume means exactly the same disk or volume that has been backed up.

A volume will not be considered original if its size, location or other physical parameters have been changed

after backup. Changing the volume letter or label does not prevent the software from recognizing the

volume.

2. If the disk or volume is recovered to a different location:

 When recovering disks: The software checks the target disks for size and volumes. A target

disk must contain no volumes and its size must be large enough to place the disk being

recovered. Not initialized target disks will be initialized automatically.

If the required disks cannot be found, you have to map the disks manually.

 When recovering volumes: The software checks the target disks for unallocated space.

If there is enough unallocated space, the volumes will be recovered "as is".

If unallocated space on the target disks is less than the size of the volumes being recovered,

the volumes will be proportionally shrunk (by decreasing their free space) in order to fit the

unallocated space. If the shrunk volumes still cannot fit the unallocated space, you have to

map the volumes manually.

5.1.4.2 Selecting target volumes

Available volume destinations depend on the agents operating on the machine.

Recover to:

Physical machine

Available when the Acronis Backup & Recovery 11 Agent for Windows or Agent for Linux is

installed.

The selected volumes will be recovered to the physical disks of the machine the console is

connected to. On selecting this, you proceed to the regular volume mapping procedure described

below.

New virtual machine

 If Acronis Backup & Recovery 11 Agent for Windows is installed.

The selected volumes will be recovered to a new virtual machine of any of the following types:

VMware Workstation, Microsoft Virtual PC, Parallels Workstation or Citrix XenServer Open

Virtual Appliance (OVA). The virtual machine files will be saved to the destination you specify.

 If Acronis Backup & Recovery 11 Agent for Hyper-V or Agent for ESX(i) is installed.

These agents enable creating a new virtual machine on the virtualization server you specify.

The new virtual machine will be configured automatically, the source machine configuration

being copied where possible. The configuration is displayed in the Virtual Machine Settings (p.

145) section. Check the settings and make changes if necessary.

Then you proceed to the regular volume mapping procedure described below.

Existing virtual machine

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 378 379

Keine Kommentare

ACRONIS Backup & Recovery 11 Betriebsanweisung Seite 128